Table of Contents
Advertisement
To add a bad track, follow these steps:
Press [Al. You see this prompt:
1.
Enter cylinder number (1 - norm):
2. Type the number of the cylinder containing the bad track and
press [M*l. You see this prompt:
Enter
3. Type the head number for the bad track and press B (To
cancel the operation, press (bcl without typing a value.)
When you complete a valid entry, it appears in the table and
you can add the next bad track, if necessary.
If you make a mistake, move the cursor block to the incorrect
track and press [cl to change the track data or [D1 to delete the
track from the table. Change the track data in the same way as
you add a track.
The maximum valid cylinder number and head number (nnnn
and nn) vary according to the capacity of the hard disk. If you
enter an invalid cylinder or head number, a reminder of the
range of values appears and the program asks you to enter the
value again.
When you finish adding all the bad tracks, press [Mwl without
typing a value. Then check the entries in the defective track
table. When you are sure the table is correct, press [Fl. The
program displays a warning about the consequences of
proceeding
with
head number (0
formatting, as described in the next section.
-
Formatting a Hard Disk
5-7
Advertisement
Table of Contents
