Epson DLQ-3500 Quick Manual page 11

4. Position the left sprocket so that the
sprocket pins are to the left of the arrow
mark on the back of the printer. Then
push down the lock lever to lock the
sprocket in place.
Note:
Printing starts at the arrow mark on the back
of the printer.The unprintable area is to the
left of the arrow mark.
5. Slide the right sprocket to roughly match
the width of your paper, but do not lock
it.
6. Slide the center paper support to the
middle of the two sprockets.
EPSON DLQ-3500 Quick Guide
7. Open the sprocket covers.
* sprocket cover
8. Fit the first three holes of the continuous
paper over the sprocket pins on both
sides. Be sure to position your paper
supply so that the printable side faces
up.
c
Caution:
Make sure the first sheet of your
continuous paper has a clean,
straight edge so that it can feed
smoothly into the printer.
9. Close the sprocket covers.
Continuous Paper (2/4)