Table of Contents
Advertisement
3-1
Installing the EDSFF SSD
Read the following guidelines before you begin to install the EDSFF SSD:
• Take note of the drive tray orientation before sliding it out.
• The tray will not fit back into the bay if inserted incorrectly.
• Make sure that the SDD is connected to the SDD connector on the backplane.
Follow these instructions to install the SSD:
1.
Press the release latch from the of the storage tray.
2.
Pull out the locking lever.
3.
Use the locking lever to slide out the storage tray.
4.
Remove two secrews on the storage tray.
5.
Install the SSD into the storage tray , secure the SSD with two screws.
6.
Re-install the storage tray with SSD into the system until it clicks.
3
1
2
4
5
8
System Hardware Installation
- 28 -
6
Advertisement
Table of Contents
