Table of Contents
Advertisement
• If you are going to stop spraying for more than 5 minutes, turn sprayer off to prevent shortened pump hose life.
• Do not allow material to dry inside pump, hoses, gun or spray system.
Texture Spraying (material supplied from
unit)
When using material
supplied from unit, insert
the Gun Plug in the top of
the gun. Make sure both
plug tabs are securely
snapped into place. Hose
plug must be removed
from bottom of gun.
1. Connect air hose and material hose to sprayer air
and material hose outlets.
2. Open air valve.
ti8528a
3. Connect air hose to gun.
ti8534a
6
ti9216a
Setup
Important
4. Connect material hose to gun.
5. Make sure burp guard is installed, Caution, page 3.
ti8701a
6. Install spray nozzle. See Recommended Nozzle
Selection Chart, Page 10.
7. Fill material hopper with 1 gallon of water.
8. Turn Material Flow Control fully to the right.
ti8705a
ti9010a
ti8706a
ti9215a
ti10191a
Setup
312301B
Advertisement
Table of Contents
