Table of Contents
Advertisement
CHAIR CONTROL FUNCTIONS (Cont'd)
Electronic Foot Control
The electronic foot control allows the user to control the
chair's manual base and back movement and access
the automatic positions.
Foot Control Operation and Programming
Operating the Automatic Positions
The "0" and "1" buttons access programmable
operating positions, also shown below. The exit "0"
position is pre-programmed at the factory.
Programming the "1" Position
Press the "0" button on foot switch or touchpad.
Chair will cycle to the exit or "0" position.
Manually position the chair to the desired working
position.
Press and hold the "Learn" button and Double-tap the
"1" button, then listen for one quick beep to confirm
the position has been stored.
Return the chair to the "0" or exit position. Press the
"1" button and confirm the position has been correctly
programmed.
Programming the "0" Position
The exit or "0" position can be reprogrammed to the
desired position in the same manner as above.
NOTE: At start up or after a power interruption,
the chair will need to be reset to access the
programmable positions. This is done by returning
the chair to the exit position ("0") and then waiting
at least 30 seconds prior to operation.
Programmable
Operating Position
Learn
Button
31064 R00
Fixed Exit
Position
13
Advertisement
Table of Contents
