Bosch HBG974K 1 Series User Manual And Installation Instructions page 27

Remove the pull-out rail.
4.
Clean the pull-out rail.
5.
→ "Cleaning products", Page 19
Note:
Further information:
21.4 Attaching the pull-out rail
Note: The pull-out rails only fit on the right or left. Make
sure when you fit them that you can pull them out to-
wards the front.
1. Guide the pull-out rail with the rear retainer
below behind the two guide rods for the required
shelf position and keep it horizontal.
Guide the rail lengthways to the rear to the guide
2.
rods, and slide both retainers onto each lower rod.
In doing so, use the rear retainer
tical rod.
Press and hold PUSH
3.
inwards
lower rod.
from
Release the PUSH tab.
4.
a The retainer clicks into place.
Pull the pull-out rail out as far as it will go and slide
5.
it back in.
Note:
Further information:
and swing the pull-out rail
until the retainer is attached in the
a
Rails en
to grip the ver-
27