Non-Interlocked Housing Warning - Beamz Light Package 3 Instruction Manual

Multipoint Laser G-50mW R-80mW
Thanks for your purchasing, please read this manual carefully before operating the system. It gives you general information
for your safe and better operation.
Installation
 Firstly, be sure that the using voltage is match with the
voltage marked on the base of the laser;
 Installation should be made by professional technician.
fix the laser lighting and adjust the angle of the moving
head to you need;
 Be sure that there is no flammable or explosive subject
nearby. The least distance is 0.5 meters. at the same
time, keep more than 15cm between the wall and laser
WARNING DATA
Lasers can be hazardous and have unique safety
considerations. Permanent eye injury and blindness
is possible if lasers are used incorrectly. Pay close
attention to each safety REMARK and WARNING
statement in the user manual. Read all instructions
carefully BEFORE operating this device.
Indicates a skill or other useful information for
special situations.
Indicates important information to protect
personnel from laser incident or injury.
Prevent damage or injury from incorrect operation.
Laser safety warming labels.
To protect the environment, recycle packing
material wherever possible.
The projector is for indoor use only, IP20.
Use only in dry locations. Keep this device
away from rain and moisture, excessive heat,
humidity and dust. Do not allow contact with
water or other fluids.

NON-INTERLOCKED HOUSING WARNING

This unit contains high power laser devices internally. Do not open the laser housing, due to potential exposure to unsafe
levels of laser radiation. The laser power levels accessible if the unit is opened can cause instant blindness, skin burns and
fires.
User's manual
lighting;
 Please check whether the fan and the exhaust is blocked;
 There is a hole for connection. when hang the laser lighting,
be sure the cable can undertake 10 times of the lighting
weight;
 The laser lighting should be fixed;
 It is essential to be earthed well for the sake of safety.
Don't throw this product away just as general trash,
please dispose of this product following the abandon
electronic product regulations in your area.
The projector must be installed in a location with adequate
ventilation, at least 50cm (20 inches) from adjacent
surfaces. Be sure that no ventilation slots are blocked.
 Avoid direct eye contact with laser light. Never
intentionally expose your eyes or others to direct laser
light..
 This laser product can potentially cause instant eye
injury or blindness if laser light directly strikes the eyes.
 It is illegal and dangerous to shine this laser into
audience areas, where the audience or other personnel
could get direct laser beams or bright reflections into
their eyes.
 It is an offense to shine any laser at aircraft.
 There are no user serviceable parts inside the unit. Do
not open the housing or attempt any repairs yourself. In
the unlikely event your unit may require service, please
contact the dealer nearest to you..

Use of controls or adjustments or performance of
procedures other than those specified herein may result
in hazardous radiation exposure
.