Auto Sensing; Forced Dvi Audio; One Channel Map; Dvb-C - LG LS341H Z Series Installation Manual

Auto Sensing

• The input is automatically switched when the input signal that you set to On is received.
• If Auto Sensing is set to Off, the input is not switched when the input signal is received.
• If SIMPLINK is set to On, HDMI is automatically set to Off and can not work.
• If the signal is removed while Auto Sensing (automatic input switch) is enabled, the input returns to the previous setting.
• If the several inputs are connected by enabling Auto Sensing and the automatic input switch is performed several times, the input returns to the
previous setting only for the last input and does not repeat the operation for the rest.
• For the AV input connected using the euro scart cable, Auto Sensing does not work for the TV input because the Auto AV function is enabled.(For
other inputs, Auto Sensing works normally.)

Forced DVI Audio

• When Forced DVI Audio is selected, the audio signal from the HDMI port will be transmitted through the RGB, AV, or Audio In #1 component ports.
• The video signal will be transmitted through HDMI to be displayed on the screen in standard quality.

One Channel Map

• If One Channel Map is On, the TV will operate as below.
- When the TV is auto-scanning, it searches both air and cable Programmes.
- In Programme Edit window, all Programmes are shown in a single list regardless of input source. (DTV/RADIO/TV) (For satellite supported
models, a Satellite input source is also included.)
- Select the Auto Sort button in the Programme Edit window to sort Programmes sequentially.

DVB-C

(Only for T/G* series)
• DVB-T/C programmes (Programmes) are searchable and selectable like following if DVB-C is On.
A. Country which uses analog only
- DVB-T(DTV) can be tuned.
VHF: 5 – 12 ( 7M Band)
UHF: 21 – 69 ( 8M Band)
- DVB-C is able to be tuned.
Frequency: 50000 – 858000 ( 8 M Band)
B. Country which uses DVB-T(DTV)
- DVB-C is able to be tuned.
Frequency: 50000 – 858000 ( 8 M Band)

WOL(Wake On Lan)

(Depending on model)
(On Europe models, it is indicated by Wake On Lan(Networked Standby Mode))
• If Set to On, User can turn on the TV by using LAN network.

DVB-C Bandwidth

• If country is 'Philippines' , DVB-C Bandwidth menu will be shown.
• Select the bandwidth of cable tuning (6 Mhz/8 Mhz). The default is 6 Mhz.

DPM

(On Europe models, it is indicated by DPM (Standby Mode))
• You can configure the DPM (Display Power Management) function.
• If this option is not set to Off, the TV set enters DPM mode when there is no input signal. DPM can be set to Off / 5 sec / 10 sec / 15 sec / 1 min / 3
min / 5 min / 10 min.
• If you set this option to Off, the DPM function is disabled.
NOTE
• Instant on supported models:
• If Instant on of Configuration Setup is enable (Reset mode or Mute Mode), USB Auto Playback can't be used.
23