Table of Contents
Advertisement
Faults and what to do about them
en
Faults
Foam may come out of
the detergent drawer.
Odours, stain formation in
the appliance.
Loud noises, vibrations
and appliance "move-
ment" during the spin
cycle.
The Touch-Display indica-
tor lights do not work
while the appliance is run-
ning.
There is detergent resi-
due on the laundry.
Spin noise during the dry-
ing phase.
Fluff found on the laundry. Run the Drum Clean — (cold) programme without laundry and detergent to
Water inlet noise during
the drying phase.
Drying duration extended.
Drying programme does
not start.
Creasing.
48
Cause/Remedy
Too much detergent used?
Mix 1 tablespoon of fabric softener with ½ litre of water and pour into
dispenser II. (Not for outdoor, sports and down-filled textiles!)
Reduce detergent dosage for the next wash cycle.
Use commercially available low foam detergent and care product which are
suitable for machine.
Run the Drum Clean 90°C programme without laundry.
Add washing powder or a detergent containing bleach.
To prevent foaming, only use half the amount of detergent recommend-
Note:
ed by the detergent manufacturer. Do not use detergents designed for woollens
or delicates.
Is the appliance aligned?
■
~ "Alignment" on page 19
Are the appliance's feet fixed? Secure the appliance's feet.
■
Have the transport locks been removed?
■
~ "Removing the transport locks" on page 14
Has there been a power failure?
■
Circuit breaker fuses blown? Reset/replace the fuses.
■
If the fault occurs repeatedly, call customer services.
■
Some phosphate-free detergents contain water-insoluble residue.
■
Select Rinse or brush the laundry after washing.
■
This is an innovative process known as thermal spinning used to reduce energy
consumption during the drying phase.
remove fluff which have accumulated inside the drum during the previous dry-
ing cycle.
The washer dryer uses water condensation technology, water is constantly
needed to dry the laundry. Therefore the water tap must be on all the time, till
the end of the drying phase.
Run the Drum Clean — (cold) programme to remove fluff which has col-
■
lected in the washer drum during the drying phase.
If the ambient temperature is higher than 30 °C, this may extend the drying
■
time.
Insufficient air circulation in the room may increase the drying time. Venti-
■
late the room.
Drying additional programme setting not selected?
■
Door not closed properly?
■
Creasing occurs when you have exceeded the maximum load or selected
■
the wrong program for the type of fabric. All the required information can
be found in the programme overview table.
Remove clothes immediately after drying; creasing may occur if they are
■
left in the drum.
Advertisement
Table of Contents
