Table of Contents
Advertisement
Programme default settings
en
0
Programme default
settings
Y ou can change the default settings for
P r o g r a m m e d e f a u l t s e t t i n g s
selected programmes. The settings can
be changed even while the selected
programme is running. The effects
depending on the progress of the
programme.
Temperature
Before and after the programme starts,
you can change the temperature
setting, depending on what stage the
programme is in, by adjusting the
desired temperature on the display.
The maximum temperature that can be
set depends on the programme that has
been selected.
Spin speed
Depending on what stage the
programme is in, you can change the
spin speed (in rpm; revolutions per
minute) before and during the
programme by adjusting the desired
speed on the display.
setting 2: 2="No spin". The water is
only drained.
You can select "No spin" to prevent
creasing if the laundry will not be taken
out of the appliance immediately after
the programme has ended.
The maximum speed that can be set
depending on the model and the
programme that has been selected.
Finish in
Before starting the programme, you
can preselect the programme end
("Finish in" time) in 0.5h increments (h =
hour) up to a maximum of 24 hours.
32
To do this:
Select a programme (except
1.
MyTime programme).
The programme duration is
displayed for the selected
programme, e.g. 2:30
(hours:minutes).
Select the ˜ button repeatedly until
2.
the required number of hours is
displayed.
The setting values are
Note:
increased using the ˜ button, and
decreased using the ~ button.
Select the A button.
3.
The programme starts.
The selected number of hours (e.g.
8h) is shown in the display panel
and counts down until the
programme starts. The duration of
the programme is then displayed.
The length of the programme is
Note:
automatically adjusted when the
programme is running. Changes to the
programme default settings or
programme additional settings may also
change the programme duration.
After starting the programme (if a
"Finish in" time has been selected and
the programme has not yet started), you
can change the preselected number of
hours as follows:
Select the A button.
1.
Touch the ˜ or ~ button to change
2.
the number of hours.
Select the A button.
3.
Advertisement
Table of Contents
