Advertisement
VII. START UP UPS / MENGHIDUPKAN UPS
1. Make sure main switch on the "off" position
and no load is connected to the outlet.
2. Connect inlet with power cord to a power
receptacle with earth ground.
3. Turn on the UPS by pressing power button.
At the same time the AC Mode indicator light
(if line voltage >140V and <300V) which
indicates UPS output is from line power.
4. Disconnect inlet from line power, the AC
Mode indicator will go out and audible alarm
will sound every 10 seconds.
5. Connect inlet to line power again and then
AC Mode indicator will light on.
6. Now your UPS is ready for operation.
Connect the equipment that is going to be
supplied by the UPS into the UPS.
VIII. TABLE OF STATUS INDICATOR / TABEL STATUS INDIKATOR
Status
Condition
All normal
Line voltage
abnormal
Line voltage
abnormal at low
battery voltage
Line voltage
normal at low
battery voltage
Remark:
A: (Backup mode) Alarm every 10 seconds
B: (Battery low) Alarm every 1 second
C: (Overload) Alarm every 0.5 seconds
D: (Fault) Continuous sounding
Buzzer
A
B
C
D
0
0
0
0
1
0
0
0
0
1
0
0
1
0
0
0
1. Pastikan tombol pada posisi "off" dan tidak
ada beban yang terpasang pada stopkontak
keluaran.
2. Hubungkan steker kabel daya ke stopkontak
jala-jala yang mempunyai arde.
3. Hidupkan UPS dengan menekan tombol daya.
Bersamaan dengan itu indikator AC Mode
menyala (bila tegangannya >140V dan
<300V) yang menunjukkan keluaran UPS
berasal dari listrik jala-jala.
4. Cabut steker kabel daya dari stopkontak jala-
jala maka indikator AC Mode akan padam
dan buzzer akan berbunyi setiap 10 detik.
5. Pasang kembali steker maka indikator AC
Mode akan menyala kembali.
6. Sekarang UPS siap menjalankan fungsinya.
Hubungkan peralatan yang akan diberi
pasokan daya pada stopkontak keluaran UPS.
Symbol
1
0
0
Check the line power, make sure
0
1
0
between 140~300 Vac.
Save your work now, the inverter
0
1
0
will be cut off.
1
0
0
Remarks
-
-
Advertisement
