Cancelling A Programme; Interrupting A Programme - Electrolux Talkie Service Manual

4.2.1

Cancelling a programme

To cancel a programme after it has been
started:
1. Open the door carefully
•
The LCD shows the message "Close the
door"
2. Simultaneously press the buttons associated to the "Cancel" function:
•
The LCD shows the message "Interrupt?"
3. Press OK/Start button
•
the machine sets itself to the cycle selection mode with "Set the programme" on the display
4. At this point, a new cycle can be selected by following the instructions reported above
NB: If the cycle has not yet been started and the door is open, all the selections made can be changed by
pressing the proper buttons.
4.2.2

Interrupting a programme

To interrupt a programme in progress:
1. Open the door carefully
By reclosing it, the cycle resumes, with a short delay, from the point at which it was interrupted.
or
2. Open the door carefully and switch the appliance off with S0 button
Press button S0 once again. The cycle resumes from the point at which it was interrupted.
NB: "Close the door" appears on the display while the door is open
Important: If the appliance is turned off or the door is opened for more than 30 seconds during the
drying cycle, the cycle will end after the regeneration phase and the appliance will be set to the cycle
selection mode when the machine is turned back on (the last cycle run will flash on the LCD).
14