Selecting A Programme - Electrolux Talkie Service Manual

Full load: when the slope of the curve is less
than the programmed standard threshold
Half load when the slope of the curve is
greater than the
threshold.
Phases in the automatic programme
Shown below are the variations in programme phases which are made as a function of dirt level and
load.
Type
Very
Load
dirty?
Full Yes
Full No
Half full Yes
Half full No

4.2 Selecting a programme

1. Open the door and turn the appliance on by pressing button S0
The LCD display lights up in one of the following situations:
A welcome message appears and the appliance is in selection mode
A welcome message appears and then the last programme run flashes (to run this programme
again, skip to point 4)
Only at first switching on the language choice is required and after setting it, the appliance in in
selection mode
2. To select a programme:
a) press once or more the button relative
to programme selection (till the LCD
shows the desired programme)
or
b) press once or more the buttons to scroll
up and down the programme list (till the
LCD shows the desired programme)
3. The following then appears on the LCD:
The name of the programme, which
flashes
The time in minutes from the beginning to the end of the cycle
Segments at the top of the display, in the same number as the number of washing phases in the
programme selected
The symbols that characterise the programme
4. Press the "OK/START" button to confirm the choice and start the cycle
5. At this point, the LCD will display advisories/alarms, for example, such as no salt and/or no rinse-aid in
the machine. Correct the problems displayed. If the 3-in-1 detergent option has been chosen, the no
rinse-aid advisory is disabled
6. Press the "OK/START" button again and close the door to start the programme.
programmed standard
Prewash Wash
68º C
55º C
cold
55º C
50º C
Phases in the programme
First rinse Second rinse
cold
13
Hot rinse
cold
68º C
no
Drying
24 min.