Operating The Drive Select Lever And Driving In Reverse - Yamaha KODIAK 450 2020 Owner's Manual

on. If the indicator light does not come on,
have a Yamaha dealer check the electrical
circuit.
3. Apply the rear brake lever or brake pedal.
4. Release the throttle lever, then push the start
switch to crank the engine with the starter.
Release the start switch when the engine has
started.
TIP
If the engine fails to start, release the start switch.
Wait a few seconds before the next cranking at-
6
tempt to allow battery voltage to restore. Do not
crank the engine more than 10 seconds on any
single attempt.
ECB00164
NOTICE
For maximum engine life, never accelerate
hard when the engine is cold!
EBU36230
Operating the drive select lever and
driving in reverse
ECB03330
NOTICE
Do not shift without coming to a complete stop
and waiting for the engine to return to normal
idle speed. Damage to the engine or drivetrain
may occur.
Shifting: Neutral to High-range and High-range
to Low-range
1. Bring the ATV to a complete stop.
2. Apply the brake pedal, and then shift by mov-
ing the drive select lever along the shift guide.
TIP
Make sure that the drive select lever is completely
shifted into position.
6-2