Citizen Eco-Drive EC1180-81L Instruction Manual page 57

1. Pull the crown out to position
2. Press the button
When all the hands have stopped moving, the watch has been reset.
• It may take up to approximately 6 minutes until all the hands stop. This is not a
malfunction.
• If the hands do not move, perform step 2 again.
After performing All Reset
You must set the watch again following the procedure below.
1. Correct the current reference
position.
After performing All Reset, the watch
is in reference position correction
mode.
See from step 4 on page 48.
2. Set the World Time.
See pages 18 to 25.
.
for seven or more seconds, then release it.
3. Adjust the time/calendar.
• When adjusting by receiving the
time signal manually:
See pages 34 and 35.
• When adjusting manually:
See pages 42 to 45.
Troubleshooting
55 55