Connecting The Control Panel - Supero AS-1041M-T2 Plus User Manual

Connecting the Control Panel

JF1 contains header pins for various front control panel connectors. See Figure
5-1 for the pin locations of the various front control panel buttons and LED indica-
tors. Please note that even and odd numbered pins are on opposite sides of each
header.
All JF1 wires have been bundled into single keyed ribbon cable to simplify their
connection. The red wire in the ribbon cable plugs into pin 1 of JF1. Connect the
other end of the cable to the Control Panel printed circuit board, located just behind
the system status LEDs in the chassis.
See the Connector Defi nitions section in this chapter for details and pin descrip-
tions of JF1.
Figure 5-1. Front Control Panel Header Pins (JF1)
OH/Fan Fail LED
Power Fail LED
Chapter 5: Advanced Serverboard Setup
20 19
Ground NMI
x (key) x (key)
Power LED Vcc
HDD LED Vcc
NIC1 Vcc
NIC2 Vcc
Vcc
Vcc
Ground Reset Button
Ground Power Button
2 1
5-5