Glow Fire Inside 106 Manual page 3

Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or similar coverings.

Arrange cord away from traffic area and where it will not be tipped over.
To disconnect heater, turn controls to off, then remove plug from outlet.

Do not inset or allow foreign objects to enter any ventilation or exhaust opening as this may cause an

electric shock or fire, or damage the heater.
To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not use on soft

surfaces, like a bed, where openings many become blocked.
A heater has hot and arcing or sparking parts inside. Do not use it in areas where gasoline, or

flammable liquids are used or stored.
Use this heater only as describes in this manual. Any other use not recommended by the manufacturer

may cause fire, electric shock, or injury to persons.
DANGER-HIGH Temperatures may be generated under certain abnormal conditions. Do not partially or

fully cover or obstruct the front of this heater.
Replacement of the lamps should be done only while the heater is disconnected from the supply circuit.

This appliance is not intended for use by persons (including children) with reduced physical, sensory or

capabilities, or lack of experience and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible for their safety. Children should be
supervised to ensure that they do not play with the appliance.
CAUTION: In order to avoid a hazard due to inadvertent resetting of the thermal cut-out, this appliance

must not be supplied through an external switching device, such as a timer, or connected to a circuit that
is regularly switched on and off by the utility.
Preparation
This product includes a GLASS panel! Always use extreme caution when handling glass.
Failure to do so could result in personal injury or property damage.
Remove all parts and hardware from the carton and place them on a clean, soft, dry surface. Parts and
assembly steps are grouped for wall-hanging or recessing use. Check the parts list to make sure nothing is
missing. Dispose of packaging materials properly. Please recycle whenever possible.
You will need the following tools (not included): Phillips screwdriver; stud finder; level; tape measure;
electric drill; 1/4" wood drill bit, hammer.
Parts and Hardware
A – Fireplace
F-Metal cover
plate
Glow Fire GmbH, James-Franck-Straße 23, 12489 Berlin
G-Box H-Plastic strip
connector
B – Wood Screws
D- Remote Control
I-Decorative
White clear crystals
C – Drywall anchors
E - "L"Shape Bracket
G - Log-set
3