Samsung WD95K5 Series User Manual page 60

Troubleshooting
Problem
HC
1C
8C
AC
AC6
DDC
If any information code keeps appearing on the screen, contact a local Samsung service
centre.
60 English
WD85K5410OX_03882L-00_EN.indd 60
High temperature heating check
• If the information code remains, contact a customer service
centre.
The WaterLevel sensor is not working properly.
• Try power off and restarting the cycle.
• Check WaterLevel Sensor wire harness.
• If the information code remains, contact a customer service
centre.
NOTE
When the washer displays the "1C" code, the washer do
draining for 3 minutes. During this time, the Power button is
inoperative.
The MEMS sensor is not working properly.
• Turn the machine off, and restart the cycle.
• If the information code remains, contact a customer service
centre.
Check communications between main and sub PBAs.
• Try power off and restarting the cycle.
• If the information code remains, contact a customer service
centre.
Check communications between main and inverter PBAs.
• Depending on the state, the machine may automatically returns
to normal operation.
• Turn the machine off, and restart the cycle.
• If the information code remains, contact a customer service
centre.
This message appears when you open the Add Door without
pressing Pause. If this happens, do one of the following:
• To add laundry, press the Add Door to close it properly. Then,
press Start/Pause and try again.
If you press the Add Door by mistake, press the Add Door
•
again to close it properly. Then, press Start/Pause to resume
operation.
Action
2019/8/26 11:56:29