Advertisement
OVERCHARGING BATTERY:
1.
Using a multi meter, check the voltage on the battery and compare it to the voltage on the Red wire connected to the starter solenoid to
engine ground.
2.
If the voltage is high on the engine compared to the voltage on the battery, do a voltage drop test and try to isolate the area where the
problem is.
3.
If the voltage is the same on the battery and the engine, but is over 15.5 volts at 4500 RPM, replace the battery with a known good
flooded wet lead acid marine cranking battery.
Web Support:
All rights reserved. Reproduction or use of content, in any manner, without express written permission by CDI Electronics, LLC., is prohibited.
Rev F • 6/19/2023
Installation and Troubleshooting Guide
This installation is to be completed by an Authorized Dealer or Professional Service
Technician. For questions regarding installation or warranty, call CDI Tech Support
at 866-423-4832. Do not return to the Dealer or Distributor where the part was purchased.
Contact CDI Electronics Directly for Return Material Authorization.
CDI Electronics, LLC • 353 James Record Road SW • Huntsville, AL 35824 USA
www.cdielectronics.com
• Tech Support: 1-866-423-4832 • Order Parts: 1-800-467-3371
Page - 6 of 6
QF-358
Advertisement
