Replacing The Handset Battery Pack; Charging The Handset Battery Pack - AT&T 9301 User Manual

900 mhz cordless telephone
Table of Contents

Advertisement

CAUTION: To reduce the risk of fire or injury to
persons or damage to the telephone, read and
follow these instructions carefully.
Use only Replacement Battery 3300.
Do not dispose of the battery in a fire. The cell
might explode. Check with local codes for special
disposal instructions.
Do not open or mutilate the battery. Released
electrolyte is corrosive and may cause damage to
the eyes or skin. It may be toxic if swallowed.
Exercise care in handling batteries in order not to
short the battery with conducting materials such as
rings, bracelets, and keys. The battery or
conductor may overheat and cause harm.
Charge the battery provided with or identified for
use with this product only in accordance with the
instructions and limitations specified in this
manual.
Observe proper polarity orientation between the
battery and battery charger.

Charging the Handset Battery Pack

This battery should remain charged up to 15 days with the
Ringer set to on; up to 30 days with the Ringer set to off.
A fully charged battery provides an average talk time of
about 12 hours.
The batteries need charging when:
The phone beeps four times when you press P
to answer or make a call.
The phone does not respond when you press
P, and no lights go on.
Place the handset in the base so the CHARGING light goes
on. The batteries will be fully charged in six hours. If you
get a low battery signal even after six hours of charging,
the battery should be replaced.
B A T T E R I E S

Replacing the Handset Battery Pack

1
Remove the battery cover by pressing on the
indentation and sliding downward.
2
Lift out the old battery pack and unplug it from the
handset.
3
Hold the new battery pack and plug the connector into
the handset. Place the battery pack into the case, so
the wires rest above the battery pack.
4
Replace the battery cover by sliding it on its track up
over the battery compartment until it snaps firmly in
place.
5
The new battery pack must be charged before using
this telephone. Place the handset in the base and allow
it to charge for six hours. Your telephone might
operate before that, but for best performance, let the
handset battery pack charge fully.
7

Advertisement

Table of Contents
loading

Table of Contents