Options; Before First Use - Electrolux WAL4E200 User Manual

14 www.electrolux.com

8. OPTIONS

8.1 Programme knob
Turn this knob to set a programme. The
related programme indicator comes on.
8.2 Start/Pause - Départ/Pause
Press button Start/Pause - Départ/Pause
to start or interrupt a programme.
8.3 Zeitvorwahl - Départ Différé
With this option you can delay the start of
a programme from 30 minutes to 20
hours.
The display shows the related indicator
and delay time.
8.4 Zeit Sparen - Gain de Temps
With this option you can decrease the
programme duration.
• Press this button one time to set
'Shortened duration' for items with
daily soil.
• Press this button two times to set
'Extra Quick' for items with almost no
soil.
Some programmes accept
only one of the two options.
8.5 Extra Spülen - Rinçage +
With this option you can add some rinses
to a washing programme.
Use this option for persons allergic to
detergents and in areas where the water is
soft.
The related indicator comes on.
8.6 Flecken - Taches
Set this option to add the stain phase to a
programme.
Use this option for laundry with hard stains
to remove.

9. BEFORE FIRST USE

1. Put 2 litre of water in the detergent
compartment for washing phase.
When you set this function, put the stain
remover into compartment
This option increases the
programme duration.
This option is not available
with a temperature lower than
40 °C.
8.7 U./Min. - T/Min.
With this option you can decrease the
default spin speed.
The display shows the indicator of the set
speed.
Additional spin options:
No Spin
• Set this option to remove all spin
phases.
• Set it for very delicate fabrics.
• The rinse phase uses more water for
some washing programmes.
• The display shows the indicator
Rinse Hold
• Set this option to prevent the laundry
creases.
• The washing programme stops with
the water in the drum. The drum turns
regularly to prevent the laundry
creases.
• The door stays locked. You must drain
the water to unlock the door.
• The display shows the indicator
To drain the water refer to 'At
the end of the programme'.
8.8 Temp.
Set this option to change the default
temperature.
Indicator = cold water.
The display shows the set temperature.
This activates the drain system.
.
.
.