Advertisement
UPPER REAR PANEL
7
6
5
4
INPUT (4)
The line-level input is of the medium impedance balanced type. The jack is a combo female XLR and 1/4" TRS
connector. Sensitivity of this input is 0.48 volts for full output, when the MIC/LINE switch (7) is in the LINE po-
sition. Also included are two summed RCA jacks that provide an unbalalaced input for connecting a cd or MP3
players.
Gnd LIFT switch (5)
Allows the shield to be disconnected from the chassis ground to alleviate hum from ground loops.
Level (6)
Controls the gain or output level of the input signal. It is used to directly set the system output level for a given
input signal.
MIC/LINE switch (7)
Switches between LINE level gain (out position) and MIC level gain (in position). MIC position increases gain
33 dB to allow use of most dynamic microphones.
NOTE: Phantom power is not supplied on the INPUT (4) jacks.
9
10
8
Advertisement
