Panasonic CS/CU-EU12AKY Series Operating & Installation Instructions Manual page 19

Indoor Unit Installation
• Do not turn over the unit without it's shock absorber during pull out the piping. It may cause intake grille damage.
• Use shock absorber during pull out the piping to protect the intake grille from damage.
For the right rear piping
Step-1 Pull out the Indoor piping
Step-2 Install the Indoor Unit
Step-3
Secure the Indoor Unit
Insert the power supply cord and
Step-4
connection cable
Insert the cables from bottom of the
•
unit through the control board hole until
terminal board area.
For the right rear and right
bottom piping
Step-1 Pull out the Indoor piping
Step-2
Install the Indoor Unit
Insert the power supply cord and
Step-3
connection cable
Insert the cables from bottom of the
•
unit through the control board hole until
terminal board area.
Step-4
Secure the Indoor Unit
For the Embedded Piping
Step-1 Replace the drain hose
Step-2
Bend the embedded piping
• Use a spring bender or equivalent to bend
the piping so that the piping is not crushed.
Pull the connection cable into Indoor
Step-3
Unit
The power supply cord and indoor unit
•
and outdoor unit connection cable can be
connected without removing the front grille.
Piping
Intake grille
Piping
Shock absorber
Right Rear piping
Tape it with piping in a
position as mentioned
in Fig. below.
Piping
Cover for
Drain
the right
hose
Cover for the
piping
bottom piping
How to keep the cover
In case of the cover is cut, keep
the cover at the rear of chassis as
shown in the illustration for future
reinstallation.
(Left, right and 2 bottom covers for
piping.)
Right and Right Bottom piping
Tape it with piping in a
position as mentioned
in Fig. below.
Piping
Cover for
Drain hose the right
piping
Install the indoor unit
Hook the indoor unit onto the
upper portion of installation
plate. (Engage the indoor unit
with the upper edge of the
installation plate). Ensure the
hooks are properly seated
on the installation plate by
moving it in left and right.
Secure the Indoor Unit
Press the lower left and right
side of the unit against the
installation plate until hooks
engages with their slot (sound
click).
Cover for
Cover for the
the left
bottom piping
piping
Cover for piping
Cover for Cover for
the bottom the left
piping piping
Hooks at
installation plate
Sleeve for
piping hole
Piping
Drain hose
Indoor unit
Installation
Unit's hook
plate
19