Table of Contents
Advertisement
en Troubleshooting
Fault
and programme
terminated.
Condensation in the
condensation tank
even though the water
drain hose is connec-
ted.
The programme does
not start.
The length of the pro-
gramme changes dur-
ing the drying cycle.
Pumping noise.
Buzzing noise.
The drying time is too
long.
44
Cause and troubleshooting
→ "Closing the base unit", Page 40.
3.
The remaining volume of condensation may remain in
the condensation container.
Not a fault – no action required.
▶
Water drain hose is not connected correctly.
Ensure that the water drain hose is connected cor-
▶
rectly.
→ "Connecting the water drain hose", Page 14
Childproof lock is activated.
→ "Deactivating the childproof lock", Page 34
▶
Start/Reload has not been pressed.
Press
Start/Reload .
▶
No programme set.
→ "Setting a programme", Page 29.
1.
→ "Starting the programme", Page 29.
2.
The programme operation is optimised electronically.
This may change the programme duration.
Not a fault – no action required.
▶
Condensation pump active.
Not a fault – normal operating noise.
▶
Compressor ventilation active.
Not a fault – normal operating noise.
▶
The base unit's filter is soiled.
→ "Cleaning the filter system on the base unit",
▶
Page 32
Fluff filter is soiled.
→ "Cleaning the fluff filter", Page 30
▶
The ambient temperature is greater than 30 °C.
Ensure that the ambient temperature is below 30
▶
°C.
The ambient temperature is lower than 15 °C.
Ensure that the ambient temperature is above
▶
15 °C.
Insufficient air circulation at the appliance's installation
location.
Ventilate the appliance's installation location.
▶
The appliance's ventilation opening is blocked.
Advertisement
Table of Contents
