en Installation and connection
Installation loca-
tion
In a washer-dryer
stack
Against a wall
4.4 Water drain hose
Condensation that forms in the appli-
ance as it dries the laundry is collec-
ted by default in the condensation
14
Requirements
Only use the ori-
ginal connection
set from the
dryer manufac-
turer when set-
ting up this appli-
ance in a
washer-dryer
stack.
Connection kit
¡
with pull-out
worktop
→ Page 28
Connection kit
¡
→ Page 28
This appliance
must only be
stacked on a
washing machine
from the same
manufacturer.
The depth and
width of this ap-
pliance must cor-
respond with the
dimensions of
the washing ma-
chine.
Do not place the
washer-dryer
stack on a plat-
form.
Do not trap the
hoses and power
cord between the
wall and the ap-
pliance.
container. Use the water outlet hose
to drain away excess condensation
directly into the waste water system.
Notes
Operate this appliance using the
¡
water outlet hose provided.
→ "Connecting the water drain
hose", Page 14
If you connect the water outlet
hose, you do not have to regularly
empty the condensation container.
→ "Emptying the condensation
container", Page 33
You can order this optional
¡
→ "Accessories", Page 28 from
our customer service.
Connecting the water drain hose
If you do not want to regularly empty
the appliance's condensation con-
tainer, connect the water outlet hose.
ATTENTION!
When operating the appliance
without the water drain hose being
connected properly, liquid may leak
out of the connecting piece.
Before operating the appliance,
▶
connect the water drain hose prop-
erly to the connecting piece.
Requirements
The appliance and the accessory
¡
have been unpacked.
→ "Unpacking the appliance",
Page 12
The appliance is installed at the in-
¡
stallation location.
→ "Requirements for the installa-
tion location", Page 13