Point indication will indicate which sample is actively being measured
Alarm Indication will indicate any samples that caused the analyzer to set an alarm output
Both Alarm and Point indication will indicate the active and any alarmed samples
The next page is for configuration of the samples and sequence that will be followed. The sample name, sample time,
and flush time are configured on this page. For more information on sample and flush time visit timing on page 26
Press the up and down arrows to set the Sample Sequence. Note that all samples must be in the sequence in order to
complete the configuration. It is possible to sample one point several times in the sequence.
Once all analyzers are configured the next button will change to finish indicating the end of configuration.
Configure Connected Device
When a device is already configured use the 'Configure Connected Device' menu to edit the configuration
Sentry Sample Sequencer 6 Controller
25