Braun Oral-B Genius 8600 Instructions Manual page 20

wipe them dry before reassembling. Unplug
the charger before cleaning. Brush head
holder (10a), compartment and protective
cover (10b), as well as smartphone holder
stand (16) are dishwasher-safe. Charger (9)
should be cleaned with a damp cloth only
(picture 5 ).
Accessories
(depending on model)
Smartphone Holder
• Before each use, make sure mirror, suction
cup surface (11d) and holding brackets
(11a) are always clean and dry (picture
B1). Use a fuzz-free cloth for cleaning
suction cup surface and mirror. In particu-
lar make sure suction cup surface and
mirror are free from any contamination
(e.g. hair, dust, oil, fuzz, dirt etc.).
• Press your smartphone holder (11) just
with enough pressure, centered at nose
level on a sturdy mirror. Then mount the
holder by pressing the lever arm (11b)
towards the mirror until it snaps in (picture
B2).
Note: Only affix on mirror to ensure safe
and correct conditions. For use in bath-
room only. Do not use in automobiles.
• Always make sure the smartphone holder
is securely mounted on the mirror before
inserting your smartphone. Place your
smartphone (portrait) sideways in
between the holding brackets (11a) by
pressing against one bracket with your
phone and sliding the other bracket to the
side (picture B2). Follow the same proce-
dure to remove your phone again.
• Adjust the overall position for the required
angle by moving the ball joint of the
holder (picture B3).
• Once done, remove your phone from the
holder. Take off the smartphone holder by
flipping the lever arm back and pulling the
tab carefully (picture B4 1./2.). Affix
smartphone holder with each use again.
• The smartphone holder should be
cleaned with a damp fuzz-free cloth only
5
(picture ). You may use glass cleaner,
alcohol or similar products (avoid products
with silicone oil). Make sure the surface is
dry and dust free after cleaning. Store in
clean and dry place. If not in use, always
remove your smartphone from the holder.
Note: Smartphone width required for usage:
minimum 58 mm, maximum 83 mm.
Caution: Small parts may come off, keep
out of reach of children.
Follow your smartphone's user manual to
ensure your phone/charger is designed for
use in a bathroom environment.
Charging Travel Case
• To charge your handle (5) place it on the
pin in the charging travel case (12) and
connect it to an electric outlet, using the
extra smart plug (13) provided.
• The flashing light (12a) of the charging
travel case indicates that the handle is
charging. Once the handle is fully char-
ged the light turns off. A full charge takes
typically 12 hours (picture D1).
Note: You may use the USB port (12b) to
charge an electric device while the
charging travel case is plugged in. The
handle can only be charged with the
smart plug (13)/(12c) not via USB port.
• The inner lid of the travel case has a
built-in smartphone holder (12d), which
can hold your smartphone while using
(picture D2). Before use, make sure your
phone fits the stand and keeps stable.
• The removable inlay (12e) of the travel
case is dishwasher-safe (picture
outer case should be cleaned with a
damp cloth only. Make sure that travel
case parts are completely dry before
reassembling and toothbrush/brush
heads are dry before storing in the travel
case.
Note: Clean stains on travel case surface
immediately. Store travel case in a clean and
dry place.
Follow your smartphone's user manual to
ensure your phone/charger is designed for
use in a bathroom environment.
Beauty Bag
Store your clean and dry toothbrush/brush
heads in the travel case (15) and place it
inside the beauty bag (14) (picture E1/2).
Clean stains on the surface immediately.
The beauty bag should be hand washed only
with lukewarm water (30 °C – 40 °C) (picture
5 ). Store in clean and dry place.
5
). The
21