Table of Contents
Advertisement
E2013 Lennox Industries Inc.
Dallas, Texas, USA
THIS MANUAL MUST BE LEFT WITH THE
HOMEOWNER FOR FUTURE REFERENCE
General
This XP25 outdoor heat pump is designed for use with
HFC-410A refrigerant only.
These instructions are intended as a general guide and do
not supersede local codes in any way. Consult authorities
having jurisdiction before installation.
IMPORTANT: BEFORE APPLYING ANY POWER (MAIN, SOLAR
OR LOW VOLTAGE) TO THE OUTDOOR UNIT, THE FIELD MUST
®
CONFIRM ICOMFORT Wi-Fi
OR HIGHER SOFTWARE. (REFERENCE ICOMFORT WI-FI
)
THERMOSTAT MANUAL
THIS UNIT IS A INTEGRAL COMPONENT OF A SYSTEM THAT
WILL REQUIRE AN ICOMFORT WI-FI
ICOMFORT™-ENABLED AIR HANDLER OR FURNACE.
iComfort™-enabled
air handler or
XP25
STEP 1 -- SETTING THE UNIT -- Clearances
CLEARANCE ON ALL SIDES — INCHES (MILLIMETERS)
6 (152)
12 (305)
36 (914)
MINIMUM CLEARANCE BETWEEN TWO UNITS
7/2013
*2P72013*
THERMOSTAT HAS VERSION 2.1
®
THERMOSTAT AND
®
iComfort WI-FI
furnace
NOTES:
S Clearance to access panel must be 30
CONTROL
inches (762mm).
PANEL ACCESS
S Clearance to one of the other three
LOCATION
30 (762)
sides must be 36 inches (914mm).
S Clearance to one of the remaining two
sides may be 12 inches (305mm) and
the final side may be 6 inches
(152mm).
Note: Dimensions are not to scale.
24
(610)
INSTALLATION
INSTRUCTIONS
Dave Lennox Signature
Collection XP25 System
HEAT PUMPS
507005-01
7/1/2013
Supersedes 6/14/2013
®
GROMMETS (2) BUSHING (1)
OUTDOOR UNIT
Improper installation, adjustment, alteration, service or
maintenance can cause property damage, personal inju
ry or loss of life.
Installation and service must be performed by a licensed
HVAC professional installer (or equivalent) or service
agency.
ACCESS PANEL
LINE SET
CONNECTIONS
FIGURE 1
Page 1
PACKING LIST
WARRANTY
RAST 6-PIN
CARD
CONNECTOR (1)
WARNING
MINIMUM CLEARANCE
ABOVE UNIT
48 (1219)
REAR VIEW OF UNIT
507005-01
*P507005-01*
®
Litho U.S.A.
Advertisement
Table of Contents
