Gravely PRO-24 HW Owner's/Operator's Manual page 11

Throttle Cable Installation
See Figure 8.
NOTE: The throttle control (Figure 15, Item 5)
is mounted on the right-hand side of the
handlebar.
1. Remove slotted hex cap screw and
cable clamp from right side of engine.
2. Route throttle cable down between
handlebar and wheel drive actuation
link.
3. Loop end of cable up and back to engine
throttle lever.
4. Install Z-bend end of cable up through
smaller hole in throttle lever.
5. Tilt cable upward until horizontal and
position over clamp mount.
6. Install clamp over cable and attach to
mount with slotted hex cap screw. Do
not tighten cap screw.
Cable
End
Throttle Lever
Clamp Mount
Throttle
Cable
2
Cable
Clamp
Cap Screw
1
Figure 8
GB - 11
7. Position throttle control (on handlebar)
all the way forward (down) to the FAST
position.
8. Push engine throttle lever fully forward
until against its stop. The throttle lever
may also be positioned against its stop
by pulling the throttle cable froward.
9. Tighten the slotted hex cap screw to
secure the clamp on the cable, securing
the cable in place.
10. Install two cable ties to secure the OPC
and throttle cables. See Figure 9.
• The upper tie secures both cables to
the right side of the handlebar just
below the support clamp.
• The lower tie is fed through the hole in
the right side handlebar support to
secure the throttle cable.
• Once secured, clip off excess ends of
cable ties.
Throttle Cable
Throttle Lever
Wheel Drive
Actuation Link
Cable Clamp
3
Cap Screw
Handlebar
Throttle
Cable