Table of Contents
Advertisement
Installation must conform with local codes or in the absent of local codes, with the American
Standard for Recreational Vehicles, ANSI A119.2 and article 551, ANSI/NFPA 70. For Marine
installation, refer to ABYC standard A-1, A-3, A-26 and A-30.
It is the responsibility of the installer to comply with the insulation clearances specified on the
serial / rating plate. The serial / rating plate is located on the bottom of cooktop.
Check location where cooktop will be installed. The location should be away from strong draft
areas, such as windows, doors and strong heating vents or fans.
CABINET INSTALLATION MODEL 3276
1. Locate Cooktop according to the istallation diagram.
2. Cut-out counter top to dimensions shown.
3. Remove protective paper from the factory installed adhesive tape located on the
bottom side of the glass around the perimeter.
4. Set cooktop into cutout. Press down to engage adhesive tape on glass top to the
surface of the counter top.
DC ELECTRICAL CONNECTION
**USE 9 to 12 VDC ONLY**
IGNITION WIRES:
RED to (+) Positive
WHITE to (-) Negative
* SEE PAGE 8 FOR MINIMUM OVERHEAD
NON-COMBUSTIBLE MATERIAL HEIGHT
AND ANSI STANDARDS FOR INSTALLATION
INSTALLATION
INSTALLATION DIAGRAM CUTOUT
20.250 (20 1/4") W
17.500 (17 1/2") H
7
Advertisement
Table of Contents
