Ketra HW-X96-X-J2 Installation Manual page 7

I N S TA L L AT I O N
S T E P 2
Mounting
(shown in Figure 3)
1. Remove top cover to access the mounting holes.
NOTE: Pull cover from corners to remove.
2. Mount the X96 Ketra controller (Figure 3).
3. Snap top cover back onto controller.
Figure 3
P/N 3662841 Rev A
© 2023 Lutron Electronics Co., Inc.
t
After installation, measure the temperature in
c
this location to verify controller is operating
within spec (158 °F [78 °C] max).
X96 INSTALLATION GUIDE | 7