Star Micronics TUP900 Quick Setup Manual page 4

Assembly – Connecting the Power Supply
The TUP900 requires a 24 VDC power source for proper operation. Star recommends use of the
PS60L-24A (pt. no. 30781440) universal power supply.
The PS60L-24A power supply is supplied with a US standard grounded power cord.
The printer end of the power supply cable is the mating Hoshiden connector for the TUP900. Simply
connect the Hoshiden power connection to the TUP900 by sliding back its collar and inserting the
power supply's male connector into the matching female connector on the back of the TUP900.
Finally, connect the 3-pronged power cord to a 110-volt grounded power source.
Note: Be sure the power switch of the TUP900 is switched to the OFF position when connecting the
power supply.
Driver Installation
Driver packages are available for the following platforms:
Windows 9x, Me, NT, 2000 and XP
Mac OS X
Linux
1
JavaPOS
OPOS
Driver Software
A product support CD was supplied with this manual. On this disc there is a "Drivers" folder in which
you will find all of the available drivers listed above.
Note: In the event that the CD is misplaced, the most current versions of Star printer drivers are
always available on our website at www.starmicronics.com.
Windows Driver Installation
The following example shows the installation of a parallel TUP900 series printer connected to the
parallel printer port (LPT1) and using the Star Line Mode Windows 2000/XP driver.
When the installation setup file is executed, the above dialogue will be shown. Click "OK" to continue.
1. Star's JavaPOS driver is platform independent and is compatible with any operating system that supports the Java Virtual Machine.
Starski says, "There
are many useful
utilities on the provided
CD. Each utility will
typically include a
'ReadMe' file or a
manual. For more
information contact
your Star
representative."