Table of Contents
Advertisement
■ Control page
The Control page is used to set the RS232 or IR display device power on/off
commands for the Automatic Power Switching mode. When this mode is
enabled, the display power off and power on commands will be sent from
RS232-A/RS232-B or IR-A/IR-B outputs after the defined Power Off Timeout
and Power On Timeout values respectively.
The Control page has three modes: RS232, CEC or IR. Power On and Power
Off commands can only be entered for the RS232 and IR modes. The
CEC mode power on and power off commands are provided by default and
cannot be changed. Only use CEC mode with displays that support CEC
commands.
15 / 24
Advertisement
Table of Contents
