Using The Built-In Web Interface - Prestel FM-42H2A User Manual

7. Using the Built-In Web Interface

The Matrix has a built-in web interface to provide a means of controlling or
configuring various settings. There are seven pages available, each of which
will be outlined in detail in the following sections.
The seven pages are:
1. Status – Displays information about the firmware and IP settings
2. Switch – Control the video routing and enabling the test pattern mode
3. Input – Displays information about the input signals and EDID settings
4. Output – Displays information about the output signals and scaler options
5. Network – Allows basic network setting management and login options
6. System – Serial baudrate, test pattern setting and firmware update
7. Control – Auto Power Control Settings and Commands
Note these seven pages are only accessible in Admin mode, when User
mode is used only the Status and Switch pages are available.
To access the web interface, enter the IP address of the Matrix into
the address bar of any web browser. If the IP address is not known, use the
RS232 commands given in the Network Settings section "r ip addr!" to
discover the IP address of the Matrix or set the product to factory default
status and IP address reset to default 192.168.1.100. After entering the IP
address the following log in screen will appear:
9 / 24