Advertisement
2.0 WALL PLATE MOUNTING BRACKET
Figures 3 and 4 show the mounting brackets to suit the two different size wall plates.
The brackets are designed to fit Australian standard electrical wall boxes in single gang and/or double gang.
To mount the wall plate to a wall box use the supplied 32mm x 6/32 threaded screws. If not using a wall box then mount
the bracket using screws suitable for the mounting surface (not supplied).
To fit the wall plate to the mounting bracket, first insert the hooks at the top of the bracket into the mouting slots on the
back of the wall plate. Then push the bottom of the wall plate against the wall making sure the bottom of the bracket
fits into the cutout/s on the rear of the wall plate. Using the supplied countersunk M2.5mm bolt/s, secure the plate to the
bracket (Note: the bolt/s will pull the plate upwards so that the hooks at the top of the bracket fit tightly into the wall plate).
3.0 SETUP
The product will be supplied blank, and will need to be configured for use. Where possible, this process is automated (usually
on newer Redback® products), requiring only user confirmation.
If a mistake is made in selection, the process can be aborted and reset at the final step (step 3 overleaf). To abort the process
continue until given a final "CONFIRM" / "CANCEL" choice, choose "CANCEL" and re-insert the SD card to try again.
First Use
Connect the wall plate to the Redback® master unit. This may be a newer product such as the A 4450 or A 4460 or an older
supported legacy product (Refer to the Redback website for compatible products).
System components are connected using "pin to pin" configuration RJ45 data cabling as shown below in figure 5. When
installing ensure all connections are verified with a LAN cable tester before switching any system component on.
A short Cat6 patch lead is supplied for setup if required.
1 TX+
568A
2 TX-
3 RX +
Straight Through
4
(both ends)
5
6 RX-
Pins Face Upwards
7
8
www.redbackaudio.com.au
Redback® A 6500A Programmable Control System
Redback® A 6500A Programmable Control System
Fig 3
Redback® Touchscreen Wall Plates
Fig 5
Redback® Proudly Made In Australia
Fig 4
8
7
6 RX-
5
4
3 RX +
2 TX-
1 TX+
3
Advertisement
