Advertisement
Redback® Touchscreen Wall Plates
1.0 WALL PLATE CONNECTION GUIDE
Figures 1 and 2 show the connection details of the wall plates.
The location of the Micro SD card and RJ45 connectors are shown.
Mounting Screw Holes
Use supplied M2.5mm countersunk bolts
Use supplied M2.5mm countersunk bolt
1
Micro SD Card
The SD card is used for firmware updates only (Note: The Micro SD Card is inserted with the contacts facing the
rear of the wall plate).
2
RJ45 Primary Connector
This is used for the connection between the wallplate and the main controller such as the Redback A 4450 or
A 4460. Connection is made using Cat5/6 cable to a maximum distance of 200m.
3
RJ45 Secondary Connector
This is used when cascading two plates. When connecting two plates on a single cable run, connect from this port
on plate 1 to the primary connector on plate 2. The combined cable run distance from the master unit to the
cascaded plate should not exceed 200m.
2
Redback® Proudly Made In Australia
1) Micro SD Card
Fig 1. A 4461 and A 4463 connections
1) Micro SD Card
Mounting Screw Hole
Fig 2. A 4462 and A 4464 connections
Mounting Slots
3) RJ45 Secondary connector
for cascade connection to a
second walll plate
2) RJ45 Primary connector.
Connect to main unit such
as A 4450 or A 4460
3) RJ45 Secondary connector
for cascade connection to a
second wall plate
2) RJ45 Primary connector.
Connect to main unit such
as A 4450 or A 4460
www.redbackaudio.com.au
Mounting Slots
Advertisement
