Table of Contents
Advertisement
Here are solutions to some of the common problems RevealCut users may encounter.
„ Cannot remove/install blade in Sizing Car: Position sizing car at least 4" from the
end cap at the bottom of the rail to allow handle to move freely.
„ Sizing cut is curved, not straight: Sizing blade is not mounted flush in sizing
cartridge. Remove sizing cartridge from sizing car housing and remove blade from
cartridge. Reinstall making sure blade is flat against cartridge body.
„ Profile Cartridge doesn't cut: Cartridge is installed backwards. Lift cover of profile
car and reorient cartridge/frame assembly so that arrows on cartridge match arrows
on car.
„ Profile cut is too high or too low: Lift cover of profile car. If adjustment needed is
within
/
up or down, use large thumbscrew on top of cartridge to adjust. If greater
1
16 "
than
/
, change to next frame size up or down. See Cutting Tiles section for complete
1
16 "
instructions.
„ Cut is fuzzy or unclean: Blade is dull. Replace blade.
„ Cut is not square: Tile was not aligned properly on platform. Be sure tile makes full
contact with tile stop to ensure straight cuts.
„ Sizing cartridge won't cut: Tile is wrong thickness for sizing cartridge used. Switch
to correct sizing cartridge.
„ Tile is wrong size: Most likely, lip measurement was added incorrectly. Recheck lip
size and re-measure grid. See Measuring Tile to Size section for complete instructions.
TROUBLESHOOTING
19
Advertisement
Table of Contents
