Using Platform Extension Bars (Rc400 Model Only) - Arrow REVEALCUT RC200 Operator's Manual

USING PLATFORM EXTENSION BARS (RC400 MODEL ONLY)

When cutting large-format tiles on the RC400 Model, the tile will often extend beyond the
platform. For example, when cutting a 4' x 4' tile, the back of the tile will extend up to 2'
beyond the rear edge of the RevealCut platform. For this reason, the RC400 comes with
extension bars which snap into the platforms on the far side of the platform, away from
the rails. These bars will support the larger tile sizes and minimize the risk of damage or
warping of tiles during the cutting procedure. When finished using, remove the bars
before storing the RevealCut unit. (Fig. 11)
Fig. 11
RAILS
RULER
EXTENSION BARS
PLATFORM
17
SIZING CAR
(Narrow Sizing
Cartridge
installed in
car)
END CAP
PROFILE CAR
(1 Profile
Frame & 1
Angled
Tegular
Cartridge
installed in
car)