Table of Contents
Advertisement
thumbscrew up so that the +
indicator is showing on cartridge
base. Tighten the thumbscrew again
and repeat your test cut from the
beginning. (Fig. 9)
ƒ To move the cut up
thumbscrew down so that the -
indicator is showing on cartridge
base. Tighten the thumbscrew again
and repeat your test cut from the
beginning.
Occasionally, the cut depth may be off by
more than
/
due to the hang-down depth
1
16 "
of the tile profile. If this is the case, you will
need to change the profile frame to the
next tile thickness – up or down as needed
– and make another test cut.
Fig. 9
/
, slide
1
16 "
PROFILE
PROFILE
CUTTING
CUTTING
CAR
CARTRIDGE
THUMBSCREW
ADJUST
CUT
DOWN
1/16"
/
For example:
1
16 "
ƒ You are cutting a
deeper-than-average hang down.
ƒ Your first test cut with the
frame is too high – it's off by
ƒ Reconfigure profile cartridge
/
1
16
assembly to use
instead of
ƒ Make another test cut.
ƒ Adjust up or down
above to secure proper dimension.
Once your test cut matches the tile's factory
edge, you are ready to start cutting tiles.
14
/
thick tile with a
5
8 "
5
/
frame setting
3
4 "
/
.
5
8 "
/
as described
1
16 "
ADJUST
CUT
UP
1/16"
profile
/
8 "
/
.
1
8 "
Advertisement
Table of Contents
