KNOVA KN BD-46L Manual page 9

OPERATION
WARNING
Do not reach across the sanding disc to
turn the belt/disc sander ON or OFF. Contact with
the sanding disc can result in serious personal injury.
POWER SWITCH
Switch
on
The belt/disc sander is equipped with a power switch that
has a built-in locking feature. This feature is intended to
prevent unauthorized and possible hazardous use by children
and others.
TO TURN THE BELT/DISC SANDER ON:
• With the switch key inserted into the switch, lift the switch
button to turn ON.
TO TURN THE BELT/DISC SANDER OFF:
• Press the switch button down to turn OFF.
WARNING
ALWAYS remove the switch key when the
tool is not in use and keep it in a safe place. In the
event of a power failure, turn the switch OFF and
remove the key. This action will prevent the tool from
accidentally starting when power returns.
WARNING
ALWAYS make sure your workpiece is not
in contact with the belt before operating the switch to
start the tool. Failure to heed this warning may cause
the workpiece to be kicked back toward the operator
and result in serious personal injury.
WARNING
To reduce the risk of accidental starting,
ALWAYS make sure the switch is in the OFF position
before plugging tool into the power source..
LOCKING THE SWITCH
Fig. 12
Switch key
removed
Switch
off
"No Hands"
Switch key
• Place the switch in the OFF position.
• Wait until the belt/disc sander has come to a full
and complete stop.
• Remove the switch key from the switch assembly. Store
key in safe place.
Fig. 11
BEVEL SANDING
Table lock knob
The worktable can be tilted from 0° to 45° for bevel sanding.
For angles 30º and above, position sander to the edge of the
work bench and mount sander in place as shown in figures 9
and 10.
To tilt the worktable:
• Loosen the table lock knob by turning it counterclockwise.
• Set worktable to desired angle.
• Tighten the table lock knob by turning it clockwise.
label
8
Fig. 13
Fig. 14