Surface Sanding On The Sanding Belt; Horizontal And Vertical Sanding - KNOVA KN BD-46L Manual

OPERATION
SANDING SMALL END SURFACES USING
THE MITER GAUGE
Miter gauge
A miter gauge is included with the tool for increased accuracy.
Use of a miter gauge is recommended for sanding small end
surfaces on the sanding disc.
NOTE: Always move the workpiece
across the sanding disc from the
left side toward the center.
Directional
arrows
Miter gauge

HORIZONTAL AND VERTICAL SANDING

The belt/disc sander can sand both vertically and
horizontally. Depending on the workpiece, use the work
support for horizontal sanding operations and use the work
table for vertical sanding operations.
• Using the hex key provided, loosen the positioning bolt
by turning the bolt counterclockwise.
• Move the sanding belt into a vertical position.
• Lock the sanding belt by retightening the positioning bolt.
NOTE: Sand long workpieces
with the sanding belt in the
vertical position by moving
the work evenly across
the sanding belt.
Fig. 15
Positioning
bolt
WARNING
horizontal sanding and use the work table for vertical
sanding. Using the sander without also using the work
support or work table may expose the operator to
Directional
pinch points and could result in serious personal injury.
arrows

SURFACE SANDING ON THE SANDING BELT

Work
support
Fig. 15 b
9
Vertical
position
Horizontal
position
ALWAYS use the work support for
Workpiece
Fig. 16
Fig. 17