Loose Parts List - KNOVA KN BD-46L Manual

ASSEMBLY

LOOSE PARTS LIST

The following items are included with the saw:
Miter
gauge
UNPACKING
This product requires assembly.
• Carefully lift sander from carton and place on a level work
surface.
WARNING
Do not use this product if any parts on
the Loose Parts List are already assembled to your
product when you unpack it. Parts on this list are not
assembled to the product by the manufacturer and
require customer installation. Use of a product that
may have been improperly assembled could result in
serious personal injury.
• Inspect the tool carefully to make sure no breakage or
damage occurred during shipping.
• Do not discard the packing material until you have carefully
inspected and satisfactorily operated the product.
• The sander is factory set for accurate sanding. After
assembling it, check for accuracy. If shipping has influenced
the settings, take to an authorized service center.
• If any parts are damaged or missing, please call
01-800-70-knova (56682), for assistance.
WARNING If any parts are damaged or missing do
not operate this product until the parts are replaced.
Use of this product with damaged or missing parts
could result in serious personal injury.
WARNING
Do not attempt to modify this product or
create accessories not recommended for use with this
tool. Any such alteration or modification is misuse and
could result in a hazardous condition leading to
possible serious personal injury.
Washer
Table
lock knob
Hex key
Sanding
disc
Work table
support
Washers
x 2
Socket head
screws
x 2
WARNING
Do not connect to power supply until
assembly is complete. Failure to comply could result
in accidental starting and possible serious personal
injury.
INSTALLING SANDING DISC AND DISC GUARD
Fig. 4
• Remove the backing from the sanding disc.
• Align perimeter of sanding disc with plate and press firmly
into position.
• Position disc guard against the lower one-third of the disc
aligning holes.
• Using the two phillips head screws, securely tighten the
disc guard in place.
5
Disc
guard
Work
Sanding
disc
Phillips
screws
x 2
Fig. 3
Disc
guard
Phillips
screws