Operation - homelabs HME030065N Manual

Operation

PROPER USE OF BEVERAGE COOLER
Energy Conservation
• The Cooler should be placed in a room that is dry and ventilated. The Cooler cannot be placed under direct
sunlight or next to a heat source (such as a radiator, stove, etc.), and a suitable insulation board must be
applied if necessary.
• Try to shorten the opening time of the Cooler's Door.
• Avoid putting warm beverages in the Cooler.
INTRODUCTION TO THE BEVERAGE COOLER'S FUNCTIONS
1. Display Controls
When turning on for the first time, the display screen will be a full display for 3 seconds and the
startup tone will ring.
2. Standby Mode
To activate "Standby" mode, hold the "Standby" button for 3 seconds. You will hear a beep and the display
area will be cut off. To deactivate "Standby" mode, press the button again. You will hear a beep and the
standard display will show.
3. Lighting
Press the "Lighting" button to turn the light on or off.
4. Temperature Setting
Press the "Increase Temperature" button to increase the temperature one degree at a time. Press the
"Decrease Temperature" button to decrease the temperature one degree at a time. To change display from
OF to OC, press and hold the "Increase" and "Decrease" button simultaneously for 5 seconds.
5. Memory Function
If turned off, this Cooler will remember any settings in place and will work according to those settings once
it's turned on again.
6. Fault Indicators
If any of these indicators are displayed, it means the Cooler has the following issues:
FAULT CODE
E1
E4
DESCRIPTION
R room sensor failure
R room defrost sensor failure
8