Before First Use; Parts Description - homelabs HME030065N Manual

Parts Description

Temperature Control
Fan
Shelf
Shelf
Adjustable
Foot

Before First Use

PLACEMENT
1. Before using the Cooler, remove all packaging materials, including bottom cushions, foam pads, and tape inside
the Cooler. Tear off the protective film on the Door and the Cooler Body.
2. Make sure the Cooler is placed in a well-ventilated, indoor environment on flat, sturdy ground (rotate left
or right to adjust the wheel to level if unstable).
3. To ensure proper ventilation, allow for at least 11.8 in (30 cm) between the Cooler and any stove, furnace.
We also advise operate this Beverage Cooler in a room of 133 cubit feet (or larger) for safety concern.
4. Keep a circulation space of at least 1.5 in (4 cm) on both sides of the Cooler to preserve power.
5. Avoid putting the Cooler in direct sunlight or too close to a heat source. Keep a safe distance of at least
11.8 in (30 cm) between the Cooler and a stove or furnace if it can't be avoided. We also advise applying an
insulation board in that case.
INSTALLATION
• Keep in upright position for 24 hours before initial power up.
• While the Cooler is empty, set the "Temperature Control" to maximum and leave for 1 hour.
• When you start putting beverages inside the Cooler, maintain a 1.5 in (4 cm) gap between the interior wall
of the Cooler and the beverages to keep the proper airflow.
• Follow steps below if you want to change the Door orientation from left-hinge to right-hinge:
1. Use a screwdriver to remove upper and lower left hinge (triangle with 3 screws).
2. Transfer the hinge to the right of the Cooler and attach to the right side of the Door.
7
Glass Door