Adjusting The Cutting Deck; General Information; Adjusting The Blade Height - Stiga ZT 3107 T Workshop Manual

WORKSHOP MANUAL
Summary
6.1 ADJUSTING THE CUTTING DECK ....................................................32
6.1.1
6.1.2
6.2 BLADE MAINTENANCE ....................................................................34
6.2.1
6.2.2
6.2.3
6.2.4
6.2.5
6.3 REPLACEMENT PROCEDURES ........................................................36
6.3.1
6.3.2
6.4 REMOVAL OF THE CUTTING DECK .................................................38
6.4.1
6.4.2

6.1.1 General information

Correct alignment of the cutting deck and blades is an essential condition to achieve even moving
of the grass; the ideal working condition is achieved when:
• the external blades are at the same distance from the ground;
• the front end of the outer blades is 6 mm lower than the rear end.
The deck is supported by four adjustable rods, which can be used to achieve optimal alignment.

6.1.2 Adjusting the blade height

1. Check the tyre pressures.
2. Bring the cutting deck to its highest position.
NOTE When measuring the blade heights it is recom-
mended to use to use a suitable measuring instrument
(1) or extensible abutments (2).
ZT 3107 T
6 - CUTTING DECK
General information ......................................................................32
Adjusting the blade height ............................................................32
Access to the lower section of the cutting deck ............................34
Checking blade alignment ............................................................34
Checking blade condition .............................................................34
Removing and reassembling the blades .......................................35
Sharpening and balancing the blades ..........................................35
Blade control belt replacement .....................................................36
Replacement of the blade flanged supports .................................37
General information ......................................................................38
Removal and reassembly of the cutting deck ...............................38

6.1 ADJUSTING THE CUTTING DECK

Chapter
6 - CUTTING DECK
EDITION PAGE
2017 32 /
59
1
2