Gigabyte R112-X30 User Manual page 50

Parameter
Server ME General
Configuration (Continued)
NM Configuration
ME UEFI FW Health Status
(Note) Advanced items prompt when this item is defined.
Description
HECI-1/2/3/4 Hide in ME
Š
– Options available: Off, Hide, Disabled. Default setting is Off.
DOI3 Setting for HECI Disable
Š
– Options available: Disabled, Enabled. Default setting is
Disabled.
Break RTC Configuration
Š
– Options available: Disabled, Enabled. Default setting is
Disabled.
Core Bios Done Message
Š
– Options available: Disabled, Enabled. Default setting is
Enabled.
Delayed Authentication Mode (DAM) Override
Š
– Options available: Disabled, Enabled. Default setting is
Disabled.
Delayed Authentication Mode (DAM)
Š
– Options available: Disabled, Enabled. Default setting is
Disabled.
MCTP Broadcast Cycle
Š
– Options available: Disabled, Enabled. Default setting is
Enabled.
Press [Enter] to configure advanced items.
Power Measurement Override
Š
– Options available: Disabled, Enabled. Default setting is
Disabled.
Power Measurement
Š
– Options available: Disabled, Enabled. Default setting is
Disabled.
Hardware Change Override
Š
– Options available: Disabled, Enabled. Default setting is
Disabled.
Hardware Change
(Note)
Š
– Options available: No, Yes. Default setting is No.
PTU Load Override
Š
– Options available: Disabled, Enabled. Default setting is
Disabled.
Press [Enter] to view the information of ME firmware status.
BIOS Setup
- 50 -
(Note)
(Note)