Preparing Electrical Wiring; Final Check - LG XD74 Series Owner's Manual

Preparing Electrical Wiring

Connect the appliance to an earthed socket in
accordance with the current wiring regulations,
protected by a minimum 15 amp circuit breaker
or time delay fuse.
Wiring must be two wires with earth.
The power cord should not be positioned
behind the appliance but within 1.2 meters of
the side so that the plug is easily accessible.
WARNING
• For personal safety, remove house fuse or
open circuit breaker or switch off power plug
before installation.
• Do not use an extension cord or double
adapter.
• The plug must be plugged into an appropriate
outlet that is properly installed and grounded
in accordance with all local codes and
ordinances.
• Repairs to the appliance must only be carried
out by qualified service personnel. Repairs
carried out by inexperienced persons may
cause injury or serious malfunctioning.
Contact our local service centre.
• Connect to a properly rated, protected, and
sized power circuit to avoid electrical overload.

Final Check

1
Turn on electrical power.
2
Turn on house water supply.
3
The door should open and close smoothly
and without harsh noises, if the unit has
been leveled correctly.
4
Run the appliance on a Rinse cycle to verify
proper operation and check for leaks.
Error Code Possible Cause and Solution
Drain hose kinked or pinched.
Feed the drainage and supply
hoses through the hole under the
sink. Then gradually slide the
dishwasher into the cabinet while
pulling on the hoses under the
sink to take up any slack. This
OE Error
helps avoid kinking the hoses or
trapping them beneath the
dishwasher.
Waste spigot under sink is
clogged.
Drill out the waste spigot under
the sink.
Water supply line kinked under
dishwasher.
Feed the drainage and supply
hoses through the hole under the
sink. Then gradually slide the
dishwasher into the cabinet while
pulling on the hoses under the
sink to take up any slack. This
IE Error
helps avoid kinking the hoses or
trapping them beneath the
dishwasher.
House water supply not turned
on.
Turn water on. Water pressure
may be too high or too low.
EN
17