Table of Contents
Advertisement
Problem
Spots and filming on
dishes.
Odor
44
Possible Cause
Wrong amount of
detergent used.
Overloading.
Improper loading.
Insufficient water
pressure.
Insufficient detergent.
Rinse aid dispenser is
empty.
The water softener has no
salt or insufficient the salt.
Water hardness level may
be set too low.
The rinse aid may be
insufficient.
Hard water buildup in the
tub
The previous cycle was
stopped before completion
and residual water
remains in the appliance.
There is food in the
bottom of the unit or in
the filter.
Unwashed dishes are left
in the unit for a long time.
Solutions
• Use the recommended amount of
detergent.
• Do not overload the appliance.
• See the Operation section.
• Water pressure should be between
20 and 80 psi.
• Add the recommended amount of
detergent. See the Operation
section.
• Refill rinse aid dispenser.
• Check whether there is the salt in
the water softener.
• Increase the hardness level setting
value.
• Refill the rinse aid or increase the
dispensing level.
• Remove all dishes, cutlery basket
and cutlery basket holder from
appliance. Only racks should remain
in tub. For best results, use citric
acid powder (can be found in
canning sections of most grocery
stores or online). Measure 3
tablespoons (45 g) of citric acid
powder. Fill main wash compartment
with measured powder. If you cannot
find citric acid powder, pour
approximately ¾ - 1 ¼ cups
(200-300mL) of white vinegar into
shallow bowl and place in upper
rack. Run Auto cycle. Do not use
detergent. When the cycle finish, run
it again.
• Turn on the power, run the Cancel
cycle option to remove the residual
water, then run the Quick cycle using
detergent but with the appliance
empty.
• Clean the filter and the interior
according to the Maintenance
section of the owner's manual.
• Cycle with one cup of white vinegar
in a appliance safe glass or bowl
placed on the upper rack. (Vinegar is
an acid, and with constant use it
could damage your appliance.)
EN
Advertisement
Table of Contents
