Special salt for dishwashers can
damage the tub due to corrosion.
To make sure that any special salt
▶
that escapes is washed out of the
tub, add the special salt to the dis-
penser for special salt immediately
before the programme starts.
Unscrew the lid of the dispenser
1.
for special salt and remove.
On initial start-up: Fill the dispenser
2.
right up with water.
Note: Only use special salt for
3.
dishwashers.
Do not use salt tablets.
Do not use table salt.
Add the special salt to the dis-
penser.
Fill the dispenser right up with spe-
cial salt. The water in the dis-
penser is displaced and forced
out.
Place the lid back on the dis-
4.
penser and turn to close.
10.4 Switching off the water
softening system
If you find the special salt refill indic-
ator irritating, e.g. when using com-
bined detergents with salt replace-
ment substances, you can switch the
indicator off.
Note
To avoid damage to the appliance,
only switch off the water softening
system in the following cases:
¡ The water hardness is max. 26 °E
and you are using a combined de-
tergent with salt replacement sub-
stances. According to the manu-
facturers, combined detergents
with salt replacement substances
can generally only be used up to a
water hardness of 26 °E without
adding special salt.
¡ The water hardness is 0 - 8 °E.
You do not need to use special
salt.
Press
.
1.
To open the basic settings, press
2.
for approx. 3 seconds.
Press
repeatedly until the display
3.
shows "Water hardness".
Press
or
4.
display shows 0 - 8.
To save the settings, press
5.
approx. 3 seconds.
a The water softening system is
switched off and the salt refill indic-
ator is deactivated.
11 Rinse aid system
11.1 Rinse aid
For optimum drying results, use rinse
aid.
Only use rinse aid for domestic dish-
washers.
Rinse aid system en
repeatedly until the
for
29