HADEF 19/90-EX Installation, Operating And Maintenance Instruction page 16

Lubricant for food industry – Selection (as option*)
13.2
SHELL
Gearing
FM Grease HD2
Load chain
--
Load hook;
Pulleys
FM Grease HD2
Gear rim;
Drive pinion
* must be mentioned by order
14 Trouble
DANGER!
Assembly, disassembly and maintenance operations must only be carried out in an atmosphere not
prone to explosion!
Please pay attention to the following in case of problems:
 Troubles with the equipment must only be repaired by qualified personnel.
 Secure the unit against unintended operation start.
 Put up a warning note indicating that the unit is not to be used.
 Secure the working area of moving parts of the unit.
 Please read the chapter "Safety instructions".
Notes on the repair of faults are found in the following table.
For the repair of failures please contact our service department.
CAUTION!
Trouble caused by wear or damage to parts such as wire ropes, chains, chain wheels, axes, bearings,
brake parts, etc., must be remedied by replacing the parts with original spare parts.
15 Remedy
Problem
Trolley runs very slowly or not at all
*) as far as applicable
16 Decommissioning
WARNING!
It is essential that the following points are observed in order to prevent damage to the equipment or critical
injury when the device is being decommissioned:
It is mandatory that all steps for decommissioning the machine are carried out in the indicated sequence:
 First secure the working area for decommissioning, leaving plenty of space.
 Read the chapter "Safety instructions".
 Disassembly is carried out in reverse order to the assembly.
 Please make sure that all operating material is disposed of in accordance with environmental regulations.
16.1 Temporary decommissioning
 Measures are as above.
 Also read the chapter "Transport and storage".
16.2 Final decommissioning/disposal
 Measures are as above.
 After disassembly, ensure that the disposal of the equipment and any materials it contains is carried out
in accordance with environmental regulations.
16
MOBIL CASTROL
--
Mobilgrease FM 222
Optimol Viscoleb 1500
Lubricant FM 100
--
Mobilgrease FM 222
Cause
Driving pinion dirty or blocked.
Hand chain is twisted or blocked*)
KLÜBER
Klüberoil 4UH 1-1500 N
--
--
Remedy
Clean the driving pinion and lubricate it, if necessary,
exchange worn parts
Place the hand chain correctly
5.52.653.01.01.05